who has what?

didnt u get a spacer for the disk with your chinese bike? if u bought a bike with front and rear disk it will come with atlease one spacer as the rear wheel is always attached its a little spacer that stops the pads from closing means no bleeding

Have not seen the Thumpster on the mx track but have witness 2 or 3 other China brands competing against modded Honda XR50's. The results is alot of bent or broken pieces from the stress of the jumps with average 150 lb riders. The Honda's had 150 up to 270 lb riders without a hitch.

Hope to see some comparisons of strength of frame/forks/swingarm along with engine/tranny. For the prices of these at $1800 plus they should not be braking as much as I have seen.

I got a dealer in florida killing all the crf150 big bores etc with the thump..ill have to get the website addy that shows the results

i was just ridding with two fellas they were on CRF-50's one was tricked out to the max the dude said he had spend $10,000 on it and converted it from the 50cc to a 110cc looked unreal but very small bikes my missus pulled up next to them on her 110cc chinese bike there wheels looked like toys i was laughing at the dude on the 50cc when they first arived he popped a wheelie and fell back 20mins later i went over a jump on my KX250 than popped a wheelie over a little bump i ended up with more than i bargain for 12 years of ridding i have had all my wheelies under control but this one i just lost it no damage to the bike other than bent handle bars i have cuts to both elbows both knees and cuts all down one side of my back smashed my head into the ground worst part about it was jumping into the shower when i got home that hurt more than the stack

Well heres the bike i just got. Its stock out of the box.

Its a 107 auto ! Damm can never get my order right.

Well here my bike now with in 24 hours from stock to this.
Thanks to Zach at http://www.devilsstable.com/ hooking me up with all the goodies.

Also a 107 motor manual has been droped in no more auto. The bikes runs great and the ride is smooths everthing works WOW. China did something right . Next test is the drit track. Zach Mecalf?

Had the chance to see the bike in person and it's really nice!!!
Kai put the motoard tires on it

heres our new bike we have put 3 hours on it well all i can say is we got ripped off something u dont expect on a new bike... few bent parts few leaks etc...
but the motor goes hard manual 4 speed 125cc
http://i3.photobucket.com/albums/y73.../125ccpic2.jpg

Well i haven't been on this site in a very long while .

I'm amazed that people are getting into motocross and motard on this site .

As far as which bike lasts and is fast/powerful,and race ready out of the box , I swear by ''PITSTER PRO'' these are 124cc ''gpx'' powered ,4 speed manual clutch,front and rear disc (06' bikes have even better brake design),and set up for an adult not a 50 lbs kid.

I race almost every weekend and this bike lasts ,and run's with all the bikes on the track very easy.

My bike now has a cam,pipe,filter and put's 10 horse power to the ground (dyno ran with a knobby tire not a street tire).

Now you can see these on line at t-boltusa.com ,very nice bikes.

All the imported bikes are getting very good,and are well worth the money ,thumpstar,pitster pro,rc motors,sikk,upc,sdg are all good and for 2 to 3 thousand less then a full race honda crf 50 they're in there.

later DEMON DAVE.
Doing it for the following sponsor's.
team T-BOLTUSA.COM
PITSTER PRO
MAJIK RIDESHOP
DEMONIC DESIGNS CLOTHING

I bought 2 CRII Xtreme 2005's (they can be had for less than 1500).

Rode them in the dirt kinda mellow for about 8-10 hours for break in.

A total blast, no problems other than a few loose spokes.

Slipped on roadrace tires Dunlop TT91's and Bridgestone 601's.

Made my own custom axle sliders from skate board wheels (cause skatin is waaaaaaay slow motion) installed Acerbis handgaurds. Everything else is stock and they will stay that way.

Went out to a minimotard track day www.misupermoto.com and loosened the spokes on both rear wheels real fast!!!!!!!!!! had to keep a close eye on the problem.

Second track day i took only 1 bike as the #2 bike had 4 broken spokes that i didn't replace yet.

Had about 30 laps in and this one hard lefty i low sided out, picked up the bike and looked it over and found all the spokes on the rear wheels right outboard side were broken at the hub............. so this is where the spokes got loose on the previous track day.........

There were minimotard dudes that said get some quality spokes before you play or you'll have issues........

Other than that i dig my bikes, 1 iz fun but 2z a race

I should have new spokes soon..........

Draggin knee at top speed is so much fun

are C1 fast out of the box

Is this some sort of minimotard/pitbike?

this aint a pocketbike thread.

Define fast.

Heres some piccies of my bike.Its an xsport mk1(extreme)

not to be dissing on china bikes but where is the klx's?? thats what i ride..

i have a thumpstar and it is awesome.Plenty of power and it takes jumps pretty well.The only thing i would upgrade is the rear shock.