X19 Oil questions

Well i just got a X19 and i was told it does not need to be -mixed- just that the oil is in a different spot and just change it sometimes.

anyways im wondering -before i even start it-

1.what kind of oil does it take??
2.what octane gas should i use 86-95???
3.when should i change the oil/HOW do i KNOW when to change it?
4.and the most important but stupid question is. where is the oil thing so i can change it? i cant seem to find it ANYWHERE on the bike??
5.is there any type of break in process like cagllari pocket bikes ect.?

it just got shipped from Pocket Bikes and Mini Bikes at MiniPocketRockets and i havnt even put gas in it yet becuse i want to know the answers to all these questions first so i know what to do to get it started.

also i was told the oil in it atm is VERY crappy and should switch it right away but i dont know where the thing is to change it or anything. =( ty for anyone who can answer those questions

PS. if you can find a picture of where the oil thing is and how to change the oiil on this bike it would be the best and very appreciated thank you.

im just kinda new to this becuse ive only been on pocket bikes and on like the X7/X8 bikes =(. so sorry for not knowing

first there is a drain plug on the bottom of your motor drain all that oil out and replace it with 3/4 quart sinthetic 10/40 motocycle oil. the gas should be 91+ and yes no mixing. i change my oil after every 10 rides or if im not riding alot i change it in like a month or so. if you have been on a pocket then you should have a good idea on how to maintain them the supers are noy to much different

hmm mmk then so use 91 unleaded gas motorcycle oil and then i can start it up and go have some fun? also are you saying every 10 -tanks- of gas is when you change it? or every 10 starts? lol

dont break it in with synthetic oil you need non synthetic motorcycle oil for break in and its your choice after if you want to use synthetic or not X18 Information Thread. Take A Look, Please. read this also make sure you DONT take out the bolt at an angle its not the drain bolt the drain bolt is the larger bolt with a tab in front of it and to change the oil i do it every month even if it was barely used to break it in just vary the speed and dont go full throttle until 3-4 tanks

ok i left the oil that it got shipped with in it for now. and put 91 unleaded gas in it about a half a tank. now. break in is about 4 tanks? correct. if so cool and ty.


ALSO ONE MORE QUESTION i havnt tried to start it yet. i was wondering if the first start can be electric or do i have to kick start it untill break in is done?

can someone answer this last question for me. where is the idle screw located at on the x19? just incase its too low or high? can someone show me a picture or 2 if they arnt busy it would really help me out.

after i get this and my other question answered ill be off riding finally i cant wait thanks

can someone answer these please ty.

sry im very excited to get riding thanks.

ok the idle scerew is on the left side of the bike there is a little gray cap covering a hole, that hole is for the really long screw driver your bike came with. the idle screw is the top screw with the spring in it. turn that screw counter clocwise to tun the idle down and clock wise to turn it up. and ya about 4 tanks no full throttle untill you finish breaking it in

and you can start it how ever you want just to clear that up for ya

to add to this yea please change out that poor excuse for oil it came with.

Ok. i think i got the hang of all of it. i know how to change the oil and i started it up and it started just fine. but havnt rode it yet. i wanted to ask first if the oil it got shipped with will get me through a few tanks of gas for the -break in- before i use synthetic oil? becuse i have to drive my car like 45 minutes away to get motorcycle oil/any oil.

so for break in will the shipped with oil be good? untill a few tanks? before i switch to synthetic?? j/w. ty. after this is answered im off to go riding hopefully.

would anyone happen to know this? ty.

still wondering. =/ ty.

i wouldnt that oil is junk and theres usually metal shavings in there