Pocketbike Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 10 Results
  1. General Pocketbike Discussion
    I am new to dirt bikes in general but especially these 50cc I bought my kids a dirt bike and wheeler I replaced the motor in the dirt bike and now when I start it with full choke it idles a little high but when I take the choke towards half way the motor revs wide open I have tried the idle...
  2. HELP! Ask our shadetree mechanics
    I've been wrenching on cars for years, but I've come into possession of a little 50cc pocket bike that I want to get running. Problem is, the wiring was hacked to pieces. I'm trying to use the remaining components to get it running with as few complications as possible. I'm not very well...
  3. Air Cooled Pocketbikes
    Hey guys I have a x8 pocket bike with a 50cc automatic engine. I found a 110cc fully manual with a kick starter and was just wondering if it will fit and line up with the motor mounts. I'm pretty sure there are some 110cc x8s out there that I've seen online. So please help me out guys.
  4. Air Cooled Pocketbikes
    Hey guys my chain is rubbing on my swingarm piviot bolt. It makes a loud metallic rubbing noise on deceleration. My chain is properly aligned and adjusted but it's still rubbing. What do you guys think it is?
  5. General Pocketbike Discussion
    This is like the most hardest decision I have to make in my life!! In your opinion which one is the best buy and why,, thank you for your help guys...
  6. Air Cooled Pocketbikes
    Hey guys I recently traded my x1 for a 4 stroke x8, the problem is that it's missing the stator cover and stator. My question is would it be cheaper to buy a stator and cover or install an inner rotor kit? Would the inner rotor kit fit this type of engine? And what's the easiest way to wire the...
  7. Air Cooled Pocketbikes
    Hey guys I recently traded my x1 for a 4 stroke x8, the problem is that it's missing the stator cover and stator. My question is would it be cheaper to buy a stator and cover or install an inner rotor kit? Would the inner rotor kit fit this type of engine? And what's the easiest way to wire the...
  8. Air Cooled Pocketbikes
    Hey guys I ran into a little problem when I tried to install my carburetor today. I'm working on a 4 stroke x7 pocket bike. The original carburetor has a cable choke but the one I ordered has a lever so that's probably the problem but i would rather have the carburetor with the lever because the...
  9. Air Cooled Pocketbikes
    Hey!! just got this pocket bike on craigslist for $110! and it needs a pull start! then in my gas tank there is 2 holes, and 2 holes in the motor for the fuel lines to go, but i only have 1 fuel line that goes through the gas tank to the motor. do i need a second one?? first time doing this...
1-9 of 10 Results
Top