Pocketbike Forum banner


  1. X18 clutch problems HELP PLEASE!!!

    General Pocketbike Discussion
    so i got my son a X18 bike, he was learning how to do clutch up wheelies. the ball on the clutch cable snapped so i got a new cable. i put the cable on and now without pulling the clutch in it will go into gear and lunge forward and die, i took the cable off and even without the cable hooked up...
  2. X19 Problems, need help. Carb issues and engine jolts

    4Stroke Midbikes
    I have an x19 with a performance carburetor, Race C.D.I, air filter, and spark plug. I don't know why but sometimes when I give it a little throttle, it boggs down like it's going to stall. It will also do it if I give it all of the gas at once. I sometimes have to ride the clutch to get it...
  3. cateye fs509 wont run?

    HELP! Ask our shadetree mechanics
    I have a cateye fs509 that wont run, I changed the pawl bolt, pull starter, pull starter catch, carb, air filter, fuel lines.. cleaned the fuel tank out and put in the right ammount of gas and oil.. there is a spark from the plug and if I add starting fluid it kicks over but dies instantly...
  4. Exhaustn bolt problem

    Air Cooled Pocketbikes
    Hi, i am new to the pocket bike planet and this is my first post. I recently bought a bike and the exhaust bolts keep popping off. M8 x 1.25 bolts fit but need to be a quarter inch longer for any washers to be able to go on and the bolt reach down into where it screws in. Unfortunately i...
  5. mini bike problem

    New to PocketBikePlanet? Star With an Introduction
    hi guys i have a 5.5 mini baja black fenders and red design fender i just want to know whats wrong with my carburetor i put starting fluid on it and it takes off then stops please help!!!
  6. X18 dies at full throttle

    Air Cooled Pocketbikes
    I purchased an '06 X18 last spring as a project bike. I don't think it was very well taken care of because when I picked it up, the carb was gummed up so bad the slide wouldn't even move. After I got that cleaned out it seemed to run fine, also put in a NGK plug. Next I replaced the stock air...
  7. x18 help needed!

    4Stroke Midbikes
    I have an x18 just bout another. The new one is having some serious issues that have me very stumped. here it is... The bike will start and stay running. When you pull in the clutch and put it in first it will not move. This is the same with all the gears. Id love to hear suggestions to help me...
  8. Problem Registering bike

    I live in Michigan and I can't figure out how to register my new Ninja x6. With my purchase I wasn't given a Manufacturer's Certificate of Origin when I bought the bike from a local dealer. So I was informed by a member of Secretary of State that I would need the year, make, and VIN # to...