Pocketbike Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
hey guys.

i was replacing a gasket on my 110cc x7, there's a bolt that's been giving me trouble. the bolt does not go in, only if i force it in. which in this case i'm afraid of damaging something. any suggestions guys.

i have provided a pic, the bolt has been labeled as "a", ignore "b".


http://www.pocketbikeplanet.com/album.php?albumid=90&pictureid=639

thanks for viewing.
 

·
Banned
Joined
·
21,742 Posts
You need to releive the timing chain pressure to realign it.................I take off the timing gear..set the bolt then use a screwdriver to pull the gear forwards so it could be set on the camshaft boss..............
 

·
Banned
Joined
·
21,742 Posts
Cam2, isnt that a special bolt that holds the guide wheel in place?

If it is you need to make sure its going through the middle of the guide wheel.

Hugh
SDscooters
LOL...yes...my phone sux and thought I was replying to another thread....The correct prognosis is now posted ...i edited the post for truth............Thanks Hugh for the heads-up......:thumbsup:
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top