Pocketbike Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello I recently had to replace the carb on my daughter's 49cc Chinese mini dirt bike it's a syx Moto I bought from Amazon. The fuel inlet nipple broke off so I bought a replacement. The bike starts fine but will die as soon as I apply throttle. I have tried it with the tire off the ground and took the air filter off and it didn't get better or worse . The carb is not what I am use to . The jet is stationary and a block slides up and down along the side of it . Is there anyway I can adjust it? Besides the single air fuel screw on the side ? I think it's flooding the motor or possibly starving it . But if it was the latter I could play with the throttle and get a little response. Because as soon as I barely twist the throttle it will die
 
1 - 2 of 2 Posts
Top