Pocketbike Forum banner

cam I need your knowledge on a couple stuff.....

857 Views 6 Replies 3 Participants Last post by  Pocketrocketnewb
Ok so after riding for a bit.I noticed my steering was extremely loose and took apart the bike.one of the bearings from the forks was busted.luckily I have the extra chassis so I took the bearings from that one which was easy.but the ones on the current frame is impossible to remove.how do you remove it sir?
1 - 7 of 7 Posts
Newish bearings


Outer ring from old bearing that is stuck
See less See more
2
Oh yea found out its a 2010 cag.weight limit is 198lbs smh
Yup, you can say that again.im looking at possible areas to reinforce it with welds and tubing
Yup, you can say that again.im looking at possible areas to reinforce it with welds and tubing

The frame is very thin-walled tubing and its harder to weld.....When my seat hoop snaped off it gave me perfect timing to make a beefier one...



To get the bearing ring out take a long screwdriver from the bottom and knock the ring up n out.........







See less See more
4
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top