Pocketbike Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
Hey guys, I have a prototype ready for a project I am working on and was wondering if anyone here can do 3D printing...

Please let me know if this is something you can do! Thanks
 

·
Super Moderator
Joined
·
2,583 Posts
The problem is and I don't know why maybe it's because of covid but filament prices are stupid expensive right now I used to get a roll of plastic for 15$ now a roll is 35$ and out of stock everywhere the same with hot ends the expensive prices and the natural high failure rate of 3D printing has sent most people's machines including mine sitting in a corner of the room collecting dust :-(
 
1 - 2 of 2 Posts
Top