Pocketbike Forum banner

go kart

807 Views 1 Reply 2 Participants Last post by  RepoBike
hey I'm not sure if this is the right spot so I just posted it here.

I have an x18 or 19 motor I can't remember and I was thinking of putting it on a go kart. mounting it isn't a problem but I was wondering electronically what I would need. like would I need a whole harness granted they are only like $25 but I would rather not buy things I don't need.

thanks
Bob
1 - 2 of 2 Posts
You dont need the whole harness. Check my thread (X18 project nightmare) CAM2 posted a harness diagram. I made mine and it works. Just the basics. No lights just the stuff to make it run. I just used my old harness it make it.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top