Pocketbike Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
so the other day my throttle cable end fell off [my fault] and got sucked into the engine bending the intake valve slightly. now i took the head off cleaned and polished everything! like a boss.

heres my question; when the pistons at TDC and the cam gears at tdc; in what position will the cam shaft be? because i just put it all back together and i had everything at TDC while the cam was @ the top lobes. like right about to open the intake.
 

·
Ninja Racer
Joined
·
2,767 Posts
there are marks on the cam sprocket and the head that line up when the flywheel lines up at the T
you bent the intake? not likely its gonna run right if you just bent it back
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top