Pocketbike Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So basically I want to change my front end of my X1 pocket bike but I’m not sure how to do it or what is a good triple tree set up that will fit the neck of the X1 without cutting it. I want to put new forks and a triple tree does anyone know anything that might work that’s from a bigger motorcycle similar to the size of a grom or a x6-x19 I’ve been on tons of websites and found parts but all are out of stock as of September 14 2021 I’m making 2 fully custom X1 bikes but I have 2 broken lower triple tree clamps and can’t find any near me also I can’t use the one from my cat eye minibike because it doesn’t fit can anyone help me or point me in a better direction
 
1 - 1 of 1 Posts
Top