Pocketbike Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
I have 3 separate parts, coil, wire and the plug. Do you just screw the wire into the coil? (Wouldn't the wire inside twist) and then insist the wire all the way into the cap? (Noticed that the wire inside the cap isn't at the end of the cap)
 

·
Banned
Joined
·
24,164 Posts
Some coils the wires unscrew off the coil, some don't. Look in the hole in the coil body where the wire fits in, is there a metal screw post in the center?
 

·
Registered
Joined
·
39 Posts
Discussion Starter #3
Some coils the wires unscrew off the coil, some don't. Look in the hole in the coil body where the wire fits in, is there a metal screw post in the center?
It's a screw
 

·
Banned
Joined
·
24,164 Posts
Okay, make sure the coil wire end is clean or new. I spread the wires inside the cable apart into a funnel shape, put the screw part in the middle and screw it into the coil body. A stock wire has a spring on the spark plug end, it goes on and is pushed thru the rubber cover. The two prongs off of the end of the spring get squeezed into the wire inside, pliers or...
 
1 - 4 of 4 Posts
Top