Pocketbike Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
picked up a bike for $30, been sitting for 3 years or so. have a couple questions. im putting new fuel lines, one of the lines has a filter connected to it inside the gas tank. which nipple on the carb will the fuel line with the filter go to?


also here is a picture of the adjuster screws on the carb. which scres adjust what?


and here is a pic of the bikes body. its a super pocket bike..any idea of the name?
 

·
Banned
Joined
·
24,145 Posts
I love the air blocker the guy put on, you need a V-stack and hp air filter. Looks like a Cateye, w/ 49cc Zenoah/Mitsu piston port engine, and someone put a Walbro pumper carb on it.
 

Attachments

·
Registered
Joined
·
316 Posts
Screws are:
top left - high speed bleed (H)
top right - low speed bleed (L)

bottom phillips head - idle speed adjustment (looks a bit odd though, the cable mount should be under the tip of this screw, not hitting the side - might just be the picture)

Hugh
SDscooters
 

·
Banned
Joined
·
21,742 Posts
picked up a bike for $30, been sitting for 3 years or so. have a couple questions. im putting new fuel lines, one of the lines has a filter connected to it inside the gas tank. which nipple on the carb will the fuel line with the filter go to?


also here is a picture of the adjuster screws on the carb. which scres adjust what?


and here is a pic of the bikes body. its a super pocket bike..any idea of the name?
You have an X3......put fuellines on both nipples and see which one picks up fuel and which one expells it then you can coordinate from there but from experience the fuel inlet is the bottom one.................Good luck with it.........
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top