Pocketbike Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just bought a jet set for a stock cag carb and they arent marked in any way. How can i tell which size is which? I was thinking some kind of water flow test. Any ideas?

Thanks
 

·
Banned
Joined
·
24,145 Posts
Online at Widgetsuppy in Oregon, I got a gauge drill set and drill vise holder for $8 and a few dollars shipping, .13mm to 1mm, or .013" to .040", a Cag .64mm main jet is about .024", I also got the 2mm and 3mm drill sets that go to .120" almost 1/8" The metal case ones have gauge # by the drill and the decimal size.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top