Pocketbike Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I'm looking for plastic for a x7 got the bike running and it is a china motor but it really shocked me. Son loves it and I even rode it thanks for the help of ddm racing carb but now we want to build a real motor for it any idea's ? And I need skin the old skin is trashed my fault stored it out side. Until I brought it back rto life it don't have to perfect skin just work able. So dig around and sell me that stuff you didn't want to fix.
 

·
Banned
Joined
·
24,145 Posts
Do you have the 2 stroke or 4 stroke X7. You can buy a $20 Cag alloy head and cut your stock piston port head under the 5th fin down, and make a ring for the head to set on. Then you can control yor squish with the cylinder height. On this engine I planned to run no base gasket but the piston was to close to the head, so I had to run a base gasket, it clears the head by .020".
 

Attachments

1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top