Pocketbike Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have bought a new speedo for my mini chopper. It was a cheap one off the internet. I used a power pack to find the two wires that move the speed dial, they are white and brown. But im finding it difficult to find which wires i am meant to connect these to that come out of the engine. There are 5 wires coming out of the engine all different colours, and i have done a bit of trial and error but it will take mo forever to figure out which are the ones that send a signal to the speedo. It is a loncin 50cc engine, is there any way of finding out which are the specific ones that send the speed signal to the speedo?

Thanks a lot :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top