Pocketbike Forum banner

Broken Bolt on X2 Ninja

2.3K views 10 replies 5 participants last post by  StrayDawg63  
#1 ·
My pull chord broke on my x2 Ninja Pocketbike. i took it off of the bike leaving the crossthreadedbolt holding on the Starter claw. i needed to get this bike to start so i took an air tool and spun the bolt to turn over the engine. the bolt then broke :mad: the bolt broke half way up the shaft and half of it in now stuck inside the bike. Any Suggestions?
 
#2 ·
Is there any way to grab the bolt with pliers or vice grips to get it out? if not you may need to Drill it and use a "Screw Extractor" set on it.

Good Luck!

Nick. :thumbsup: :) :thumbsup:

(edit)

You might be able to grind a slit in it to fit a flat-head screwdriver?